16.08.2023 aktualisiert
100 % verfügbar
HW/RF Design Engineer and EMC Certification Expert
Feucht, Deutschland MSc. Electronic Engineer
Skills
Altium DesignerJiraDigitale ElektronikHardware-DesignPythonLtspiceMicrosoft ProjectHochfrequenztechnikPspicePcb Layout
Altium Designer, Cadence, digital circuits, Hardware Design, Hardware Development, Jira, LTspice, Excel, Power Point, Microsoft Project, Word, circuit analysis, PCB layout, PSpice and Python
Sprachen
DeutschgutEnglischverhandlungssicher
Projekthistorie
- Hardware Design and Product Development
- Development of analog and digital circuits.
- Creation of schematics for radio frequency circuit design and PCB layout with Altium Designer.
- Execution of analyzes and simulations for circuit parts with tools such as PSpice and LT Spice.
- Ensure all aspects of electrical design and development including schedule adherence, cost, and performance/quality of the end product.
- Creation of electrical and functional test procedures.
- Verification of the developed hardware and writing technical documentation.
- Good knowledge of microcontroller and it’s peripherals.
- Certification and Product Compliance
- Conducting a preliminary study for EMC and safety testing.
- Perform pre-certification testing of EMC compliant product according to ETSI EN 300 220.
- Circuit design and spark ignition calculation specifically for Atex environment.
- System Architecture Responsibilities.
- Analysis of customer and system requirements.
- Creation of test specification considering the requirements from OEM’s.
- Did feasibility study and review of the PCB Drawings, layout, BOM and its schematic.
- Benchmarking of the electronic components (e.g. Mosfets, ADC).
- Investigation of the mosfet slew rate, try to reduce it under the consideration of EMC boundaries.
- Software Development and Testing.
- Basic knowledge in Embedded Systems & C programming.
- Experienced in SPI, UART, I2C and CAN protocol.
- Diagnose hardware and software failures testing and made report out of it.
- Perform testing on Arduino Atmega board, did coding of C++ language and cross check the accuracy of the external temperature sensor according to its datasheet.
- Hardware Development and Testing.
- Good understanding of Hardware Development and PCB designing (both analog and digital).
- Sound knowledge of power electronics and strong handling of Oscilloscope, soldering and fault diagnostic.
- Did simulation of circuit analysis as well as validation of hardware design and made prototyping out of it.
- Performed worst-case analysis of hardware design according to ISO 26262.
- Piping & Instrument Diagrams and Drawings Reviews.
- P&ID study and review with initial material take-off from P&IDs.
- Familiarization with engineering drawings such as cable layout, junction box, wiring diagram, hook-ups diagram, block diagram and documents including instrument list, i/o list and cable schedule.
- Selection of Sensor Devices and Cost Planning.
- Familiarization and selection of sensors and gauges such as temperature, pressure, level and flow gauges.
- Preparation of instrument index, I/O list, datasheets, BOM and MTO.